Service manual

DISPLAYS, MESSAGES, AND ALERTS: Using the Optional Vibrate Function
68P80401P01-O 3-7
3.5 Using the Optional Vibrate Function
The vibrate function (VibraCall) notifies the user of incoming phone or dispatch calls, DC/GC calls,
messages, notifications, and call alerts.
If the unit is set for Vibrate in any mode, it will vibrate for 1/2 sec during the power-up sequence.
To set unit to vibrate for all calls:
1. Using the keypad, press
the Menu key
.
2. Scroll to Ring Tones, then press the OK button.
3. Scroll to Vibrate All, then press the OK button.
4. Scroll up or down to set Vibrate All on or off.
5. After you select a Vibrate mode, the unit vibrates for 1/2 sec while exiting the menu.
The following table describes the cadence for each vibrator mode:
To set unit to vibrate for Direct Connect and Group Connect calls only:
1. From the main menu, select Settings > 2-Way Radio > Alert Type.
2. If Alert Type does not appear, from the main menu select Ring Tones. Make sure Vibrate All
or Silent All is set to Off. Repeat step 1.
3. Press the OK button to change.
4. Scroll to Vibrate.
5. Press the OK button to select.
Voice Mail
Received in Idle
Spkr Spkr 2400/
2743Hz
8x(64ms on 2400Hz + 64ms on
2743Hz) every 30 seconds
Voice mail received while unit is
idle
Voice Mail
Received in
Interconnect
Ear Ear 2400/
2743Hz
8x(64ms on 2400Hz + 64ms on
2743Hz) every 30 seconds
Voice mail received while unit is
in interconnect mode
Table 3-6. Vibrator Settings
Mode Cadence
Vibrate All or Selectable Vibrate 2x(500ms on, 500ms off) + 500ms on + 2.5 sec. off
Ring Tones Three Vibrate Only cadences, followed by an audible ring tone until
answered or party hangs up
Off Turns off the vibrator function
Table 3-5. Alert Tones (Continued)
Tone Low High Freq Cadence When Tone Occurs