Service manual

BASIC LEVEL CHECKS AND SELF TESTS: Mechanical and Electrical Checks
68P80401P01-O 5-7
If this test is successful, place the unit’s battery in the reference unit and re-run the test.
5.5.7 Camera Test
1. Enter the MA (Model Assembly) Mode. Press and hold three number keys simultaneously with
the Power key, such as 1-2-3, 4-5-6, 7-8-9.
2. Scroll the display to Camera View Finder. Ensure that the camera lens is clean and not
damaged.
3. Verify that the viewfinder shows the captured image correctly. Check for noise, poor color,
synchronization error.
4. If the image is defective, the camera may need to be replaced via a new flip assembly.
5. Repeat steps 1 to 3.
6. If the image is defective, the main display may need to be replaced via a new flip assembly.
7. Repeat steps 1 to 3.
8. If image is defective, replace the main board.
9. Repeat steps 1 to 3.
10. If the test is successful, power down the unit.
5.5.8 Bluetooth
®
Hands Free Test
1. From the main menu, select Bluetooth.
2. If you want to create a bond and connect with the given device, select Hands Free > [Find
Devices]. -or-
If you want to create a bond to have it available for future use, select Link to Devices.
3. Select the device you want.
4. Enter a PIN.
5. Press the Option key under Done.
6. If necessary, enter the same PIN for the other device.
7. Select Bond.
Connecting to a Stored Device
If you have previously connected to a device, the device will be stored on your phone so you can
connect with it easily.
1. From the main menu, select Bluetooth > Hands Free.
2. Select the device you want to connect to.