Service manual

BASIC LEVEL TEST MODES AND PROCEDURES: Connecting the Unit to the RSS Workstation
68P80401P01-O 6-9
To connect the unit to a PC using the iDEN RS-232 (serial) or USB data cable
(Figure 6-1):
1. Insert the 17-pin connector on the data cable to the 17-pin connector located at the base of the
unit.
2. Attach the other end of the data cable to the RS-232 port or USB port on the RSS computer
workstation that is used for testing purposes.
Figure 6-1. Data Cable Programming Setup
Refer to any relevant Radio Service Software Read-Me’s or active iDEN Service Bulletins for more
information on setting up your test computer as an RSS workstation.
NOTE: For faster codeplug reading using an RS-232 connector, enable the QuickComm feature in
the RSS configuration setup.
6.5.1 Codeplug Help
If the codeplug is corrupted, the unit displays a SELF CHECK ERROR 0800 message. The
procedure for repairing a corrupted codeplug is described in the RSS online Help System.