Service manual

PREPARING FOR FIELD LEVEL TESTING: Back Housing
7-8 68P80401P01-O
7.8 Back Housing
Required Tools: T-6 Torx bit, black stick.
Preparation: Remove battery cover, extend antenna. Open audio jack seal, accessory connector
seal, and memory card seal.
7.8.1 Remove:
1. Remove four T-6 screws—one in the antenna tube channel (see Figure 7-4).
2. Gently squeeze the front housing at the number 7 and 9 keys to separate the housing clips (see
Figure 7-5).
3. Once the housings are free, do not stress flex strip near PTT key. Set aside audio jack and
memory card seals.
4. Wedge black stick under flex pad to unseat the housing flex connector (see Figure 7-6).
NOTE: Do not touch flex contacts with fingers or dirty tools. Do not bend or crease the flex
strip.
7.8.2 Install:
1. Reattach flex connector carefully without contamination.
2. Bring housing halves together checking alignment of flex, PTT/volume keypad, audio jack and
memory card seals. Press housing halves together at number 7 and 9 key locations to engage
clips.
3. Torque screws to 1.8 in/lb (2.1 in/lb new plastic).
Figure 7-4.