Laptop User Manual

1-8 Computer Group Literature Center Web Site
Hardware Preparation and Installation
1
Stand-Alone Operating Mode (J8)
The MCPN750A has a stand-alone operating mode that allows the
MCPN750A to function without the clock from the system slot controller
board. Installing a jumper across pins 1 and 2 of J8 enables the stand-alone
mode. The J8 jumper must be removed for normal operation.
Note An MCPN750A configured for stand-alone mode should not be
installed in a chassis with a system slot controller board. This will
result in unpredictable system operation. See the section on
System Considerations for additional information.
2
1
2
1
Enables Stand-Alone mode
Remove jumper for normal operation
J8J8
(Factory Configuration)