User`s guide

Installing on Windows NT

2 Log on as Administrator.

3 Insert the im240 Wireless Modem Installation and Application

Software CD in your CD-ROM or DVD drive.

• If the im240 Wireless Modem and Installation and Application

Software installation program does not start automatically, select

Start, Run, and then type d:\setup.exe, where d refers to the letter

of your CD-ROM or DVD drive.

4 Use the Next and Back buttons to navigate through the Wizard.

Using the default settings for the Destination Location and Program

Folder is recommended unless you have special requirements and

an advanced understanding of PC configuration.

5 When prompted, users will be required to enter the COM port and

the IRQ that will be assigned to the im240 Wireless Modem. To get

the next available COM port, go to Control Panel and open Ports.

Select a COM port that is not used. For example, if ports displays

COM1, then select COM2/COM3/COM4.

Note: To find an available unused IRQ, go to:

• Start > Programs > Administrative Tools > Windows NT

Diagnostics.

• Click on the Resources Tab and click the IRQ button in that

property page.

• This page lists all the IRQs that are currently in use.

• Select an IRQ from this list 3-7, 9-12, and 15 that is not in use, for

example 10.

• After entering the COM port and IRQ, the im240 Wireless Modem

is installed as a COM port

6 When prompted, shut down Windows.

7 Turn on your laptop and start Windows.

8 After restarting you will be prompted to install the wireless modem.

9 With the SIM card inserted into the im240 Wireless Modem, and the

label of the im240 Wireless Modem facing up, carefully insert the

im240 Wireless Modem into your laptop card slot.

10 On the next page, click Have Disk to browse to the location where

you installed the Dashboard and select the subfolder "Driver". Click

OK and Click Next.