Operation Manual
USING THE PHONE 23
ENGLISH
4. When the other handset answers the intercom call, press MENU on the calling
handset to set up the conference call.
5. Press /HOME on any handset to end a three-party conference call and leave the
other handset engaged with the caller.
NOTE
During an external call, pressing /HOME or /SPEAKER on any handset, will join in the
call and set up a conference call.
3.22 Setting the dial mode
The default dialing mode is suitable for your country and network operator. It is unlikely that
you should need to change this setting unless advised to do so.
1. Press MENU and then VOL+ or REDIAL/VOL- to select
SETUP BS
.
2. Press MENU to select
DIAL MODE
.
3. Press MENU and then VOL+ or REDIAL/VOL- to select
TONE
or
PULSE
.
4. Press MENU to save the setting.
NOTE
If pulse mode is selected, press */TONE to switch from pulse to tone dialing temporarily when
dialing out. After the call is ended, the dial mode will change back to pulse automatically.
3.23 Setting the flash time
The default flash time is suitable for your country and network operator. It is unlikely that you
should need to change this setting unless advised to do so.
1. Press MENU and then VOL+ or REDIAL/VOL- to select
SETUP BS
.
2. Press MENU and then VOL+ or REDIAL/VOL- to select
FLASH TIME
.
3. Press MENU and then VOL+ or REDIAL/VOL- to the flash time you want. (8 options
are available:
90
,
100
,
110
,
250
,
300
,
400
,
600
and
700MS
)
4. Press MENU to save the setting.
3.24 Setting the area code
1. Press MENU and then VOL+ or REDIAL/VOL- to select
SETUP BS
.
2. Press MENU and then VOL+ or REDIAL/VOL- to select
AREA CODE
.
3. Press MENU and enter the area code.
4. Press MENU to save the setting.