Operation Manual
24 USING THE PHONE
3.25 Registration
3.25.1 Registering a handset
Up to 5 handsets can be registered to one base. The original handset is pre-registered to
use. Additional handsets must be registered to the base before you can use them.
To register an additional handset,
1. Press MENU and then VOL+ or REDIAL/VOL- to select
SETUP HS
.
2. Press MENU and then VOL+ or REDIAL/VOL- to select
REGISTRATION
.
3. Press MENU and then VOL+ or REDIAL/VOL- to select
YES
or
NO
.
4. Select
YES
and press MENU to enter the registration procedure as follows:
1)Press and hold FIND for around 4 seconds on the base, release once
IN USE LED is
flashing.
2) Place the unregistered handset on the base or charger.
3) A confirmation tone is generated if registration is successful.
HANDSET X
is displayed
where X denotes the number of handsets, and then the phone returns to idle.
To register an originally unregistered handset, follow steps 1) through 3) above.
3.26 Resetting all settings
1. Press MENU and then VOL+ or REDIAL/VOL- to select
RESET SETTINGS
.
2. Press MENU and then VOL+ or REDIAL/VOL- to select
ALL SETTINGS
.
3. Press MENU to select
YES
. All personalized settings will be reset to default.
NOTE
All of your phonebook entries, calls list and redial list will remain unchanged after resetting.
3.27 Paging/Finding handsets
Press FIND on the base. All handsets registered to the base will ring or beep.
To stop the paging, press FIND again, or press any key on the handset, or place the handset
on the base.
3.28 Using your answering machine
3.28.1 Playing messages
1. Press /MUTE on the handset from idle mode. New messages will be played followed
by any older messages.