user manual

Configure and Environment Commands

D-2

Note that the parameters that are quoted are left-justified character

(ASCII) strings padded with space characters, and the quotes (") are

displayed to indicate the size of the string. Parameters that are not

quoted are considered data strings, and data strings are right-

justified. The data strings are padded with zeroes if the length is not

met.

In the event of corruption of the board information block, the

command displays a question mark "?" for nondisplayable

characters.The following warning message:

(

WARNING: Board Information Block Checksum Error)

is also displayed in the event of a checksum failure.

Using the I option initializes the unused area of the board

information block to zero.

Modification is permitted by using the M option of the command.

At the end of the modification session, you are prompted for the

update to Non-Volatile RAM (NVRAM). A “YÓ response must be

made for the update to occur; any other response terminates the

update (disregards all changes). The update also recalculates the

checksum.

Be cautious when modifying parameters. Some of these parameters

are set up by the factory, and correct board operation relies upon

these parameters.

Once modification/update is complete, you can now display the

current contents as described earlier.