user manual

Configure and Environment Commands
D-6
D
Table D-1. ENV Command Parameters
ENV Parameter and Options Default Meaning of Default
Bug or System environment [B/S] S System mode
Field Service Menu Enable [Y/N] Y Display Þeld service menu.
Remote Start Method Switch
[G/M/B/N]
B Use both the Global Control and Status
Register (GCSR) in the VMEchip2, and
the Multiprocessor Control Register
(MPCR) in shared RAM, methods to
pass and start execution of cross-loaded
program.
Probe System for Supported I/O
Controllers [Y/N]
Y Accesses will be made to VMEbus to
determine presence of supported
controllers.
Negate VMEbus SYSFAIL* Always
[Y/N]
N Negate VMEbus SYSFAIL after
successful completion or entrance into
the bug command monitor.
Local SCSI Bus Reset on Debugger
Startup [Y/N]
N Local SCSI bus is not reset on debugger
startup.
Local SCSI Bus Negotiations Type
[A/S/N]
A Asynchronous
Ignore CFGA Block on a Hard Disk
Boot [Y/N]
Y Enable the ignorance of the
ConÞguration Area (CFGA) Block (hard
disk only).
Auto Boot Enable [Y/N] N Auto Boot function is disabled.
Auto Boot at power-up only [Y/N] Y Auto Boot is attempted at power up
reset only.
Auto Boot Controller LUN 00 LUN of a disk/tape controller module
currently supported by the Bug. Default
is $0.
Auto Boot Device LUN 00 LUN of a disk/tape device currently
supported by the Bug. Default is $0.
Auto Boot Abort Delay 15 This is the time in seconds that the Auto
Boot sequence will delay before starting
the boot. The purpose for the delay is to
allow you the option of stopping the
boot by use of the Break key. The time
value is from 0 through 255 seconds.