user manual

Hardware Preparation and Installation
2-2
2
Overview of Start-up Procedure
The following list identifies the things you will need to do before
you can use this board, and where to find the information you need
to perform each step. Be sure to read this entire chapter and read all
Caution notes before beginning.
Table 2-1. Start-up Overview
What you will need to do ... Refer to ... On page ...
Set jumpers on your MVME177
module.
Hardware Preparation 2-4
Ensure that EPROM devices are
properly installed in the sockets.
Hardware Preparation 2-4
Install your MVME177 module
in the chassis.
Installation Instructions 2-12
Set jumpers on the transition
board; connect and install the
transition board, P2 adapter
module, and optional SCSI
device cables.
The userÕs manual you received
with your MVME712 module, listed
in Related Documentation
1-9
You may also wish to obtain the
Single Board Computer SCSI
Software UserÕs Manual, listed in
Related Documentation
1-9
Connect a console terminal to
the MVME712.
Installation Instructions 2-12
The userÕs manual you received
with your MVME712 module, listed
in Related Documentation
1-9
Connect any other optional
devices or equipment you will
be using.
The userÕs manual you received
with your MVME712 module, listed
in Related Documentation
1-9
EIA-232-D Interconnections A-1
Port Numbers B-34
Disk/Tape Controller Data C-1
Power up the system. Installation Instructions 2-12
Front Panel Indicators (DS1 - DS4) 3-3
Troubleshooting the MVME177;
Solving Start-up Problems
F-1