Specifications

LD-G-3 / LD-W-3 English
Page 33
!
Online-programming
In the programming mode, the starting velocity, the maximum velocity
as well as the acceleration and brake delay are tested and directly
saved. For that reason you need an isolated oval section of track for
programming. As soon as you finish a menu point, i.e. before you
switch the function "function" to "off", you should always set the speed
control knob to "0". Otherwise the locomotive starts to run at the
beginning of the following menu point.
Entering the present address is not necessary to access the
programming mode of the decoder. The decoder which is on the
programming track is programmed after the switching-over into the
programming mode. To avoid unintended programming of a decoder,
no other locomotives with this decoder type should be on a track
connected to the programming track.
Accessing the programming mode
Put the locomotive on to the track and reset the central unit. Set the
function "function" of the central unit to "off". Enter the address "78" at
the central unit.
Caution:
It does not matter if you have already saved a new address. You
always have to enter the address "78" to access the programming
mode.
Push the "stop" button at the central unit. Next, operate the direction
switch and hold it in that position while briefly pushing the "go" button.
As soon as the front lamp of the locomotive flashes (after ca. 2
seconds) you are in the programming mode and can release the
direction switch.
Notice: Some types of central units do not allow you to access to the
programming mode when the Motorola II format is set (e.g. Intellibox*
from Uhlenbrock). These central units must be set to Motorola I format
to program the locomotive decoder.