Specifications

LD-G-1 / LD-W-1 English
Page 41
!
Connecting the LD-W-1
Follow the connections diagrams (fig. 1a and 2b)! Solder the connection
to the slider at point X3 and the connection to the housing to point X2.
These two connections can be exchanged without effecting
functionality. Solder the connections to the motor at the points X11,
X12 and X13.
Connecting the lighting and other accessories
Disconnect any existing diodes in the leads to the lamps.
Connections to the outputs X7 to X10
The accessories connected to the outputs X7 to X10 are switched via the
function keys F1 to F4. You will find the assignment of the outputs to the
functions keys in the connections diagram Fig. 1.
Connections to the outputs X4 to X6
The accessories connected to the outputs X4 to X6 are assigned freely to
the function keys “function“ and F1 to F4 during the programming of the
decoder. For that reason it is possible to connect the accessories to the
function outputs any way.
If you want to use the decoder factory settings for the outputs X4 to
X6, you have to connect the lighting and the accessories as follows:
Front lighting: X4
Back lighting: X5
Accessory independent of the direction to be switched via „function“: X6
Connections to the return conductor
Follow the connections diagrams (fig. 1a)! If the lamp or the accessory
is already connected with one side to locomotive ground you should
solder a diode between the decoder and the lamp or accessory. If not,
connect the second side of the lamp or the accessory to the return
conductor of the decoder (point X1).
Caution:
If you connect the loads to the return conductor for all functions (point