Specifications

English LD-G-1 / LD-W-1
Page 44
!
7. Maximum speed for velocity characteristic 1
8. Velocity at speed level 1 for velocity characteristic 2
9. Maximum speed for velocity characteristic 2
10. Automatic shuttle service: active or inactive
11. Acceleration delay for velocity characteristic 1
12. Brake delay for velocity characteristic 1
Accessing the programming mode
Put the vehicle on to a programming track or on the layout and reset
the central unit (by simultaneously pushing the buttons “stop” and “go”
for some time). Enter the address "78" at the central unit. Set the
function key "function" of the central unit to "off".
Attention:
It does not matter if you have already saved another address. You
always have to enter the address "78" to access the programming
mode. If you put the vehicle for programming on the layout take off all
other vehicles with deocders with online-programming. If not you
programm these vehicles as well.
Push the "stop" button at the central unit. Next, operate the direction switch
and hold it in that position while briefly pushing the "go" button. As soon as
the lamps connected to the outputs X4 to X6 flash (after approx. 2 seconds)
you are in the programming mode and can release the direction switch.
Notice: Some types of central units do not allow you to access to the
programming mode when the Motorola II format is set (e.g.
Intellibox** from Uhlenbrock). In order to start the programming
mode these central units must be set to Motorola I format for the
address “78”. As soon as the decoder is in the programming mode, the
central unit must be set back to Motorola II format.
Starting from this menu level you can:
Without any further inputs: Set the address and the functions.
After pushing the function key F1: Query the address.
After pushing the function key F2: Perform a decoder reset.
After pushing the function key F3: Set the driving characteristics.