Specifications

LD-G-1 / LD-W-1 English
Page 45
You can finish the programming mode at any time by disconnecting the
vehicle (pushing the button „stop“ or taking the vehicle from the track).
Setting the locomotive address and the functions
1. Setting the locomotive address
You are in the menu point „Setting the locomotive address“ when all
lighting connected to the function outputs X4 to X6 flash regularly.
Enter the desired address. You do not need to enter the old address.
Confirm your setting by switching the function key „function” on and off
once. After the taking-over of the locomotive address the regular
flashing of the connected lighting stops and the decoder proceeds
immediately to the programming of the first function output.
2. Setting the function outputs
Now the function outputs X4, X5 and X6 are programmed one after the
other. The function keys are assigned in succession, and the dimming
function is set for each output.
Assigning the function keys: While the programm continuously
switches the ouput to be programmed on and off (and the lighting
connected to the output flashes) switch on the functions key(s) F1 to F4 on
your central unit with which you want to switch the output in later
operation. You can assign several function keys to one output of the
decoder. Please notice that in operation the second velocity characteristic is
activated and the acceleration and brake delay is deactivated via F4.
If you want to switch the function output in operation via „function“ you
have to make the following settings:
Speed level 1 : Output will be switched on during backwards motion.
Speed level 2 : Output will be switched on during forward motion.
Speed level 3 : Output will be switched on independent of the direction
of motion.
Advice: On the Märklin* Central Unit 6021 the speed levels 1,2 and 3
correspond to the settings 20, 40 and 60.
Confirm your settings by switching the function key „function“ on and
off once.