Specifications

English LD-G-1 / LD-W-1
Page 48
Then it brakes with the brake delay set at the speed knob. You may
modify the brake delay by operating the speed knob. Speed level 0
corresponds to no brake delay, speed level 14 (250 on the Märklin*
Control unit) to maximum brake delay. As soon as the brake delay is set
as desired you have to confirm your setting by switching the function
key „function“ on and off once.
Setting the acceleration delay: Now switch on the auxiliary function
F1. The locomotive accelerates with the acceleration delay set at the
speed knob and then brakes with the brake delay set before. Continue
as described in section: „Setting the brake delay“. As soon as the
acceleration delay is set as desired you have to confirm your setting by
switching the function key „function“ on and off once.
During this programming step you may switch the automatic shuttle
service on or off as required by operating F3 and also change between
setting the brake or the acceleration delay by operating F1.
When all settings are made, you close the programming mode by
disconnecting the decoder (pushing the button „stop“ or taking the
locomotive from the track).
Querying the decoder address
You get to this programming step only by operating the function key F1
on the top menu level after having started the programming mode. The
lighting of the locomotive now starts to flash. Two flashing signals
interrupted by a short stop transmit the coded address. After a longer
pause the two flashing signals are repeated. You’ll find the meaning of
the flashing signals in the appendiix. You get back to the standard
operation by disconnecting the locomotive.
Performing a decoder reset
You get to this programming step only by operating the function key F2
on the top menu level after having started the programming mode. By
operating the function key F2 you restore the factory settings (and all
other settings are deleted). Then the decoder continues automatically
in standard operation.