Specifications

LD-G-1 / LD-W-1 English
Page 37
Dimming: The function outputs X4 to X6 can be dimmed individually.
Example of use: The electric bulbs of older locomotives made for
analogue operation can be dimmed and thus must not be exchanged
after the mounting of the decoder.
Example of use: The front lighting is assigned to two different function
outputs. Via one function key you can switch the standard lighting, via
another the long distance lighting.
Check back of the address
In the programming mode you can query the address. The address is
transmitted coded by the flashing of the lighting of the locomotive.
Online-programming
The address, the driving characteristics and all functions can be
programmed online. This means:
§ In order to start the programming mode and to set the desired
(new) address, it is not necessary to enter the present address.
§ While programming the driving characteristics (starting and
maximum velocity, acceleration and brake delay) the locomotive is
running. By operating the speed knob the driving characteristics are
altered. As soon as these are set as desired, they can be saved
directly (online).
§ In the programming mode the function to be set is active. This
makes it easier to assign the outputs to the function keys. The
dimming function can be altered via the speed knob. As soon as it
is set as desired, it can be saved directly (online).
Setting the address via solder bridges
It is possible to set four different addresses via solder bridges, as an
alternative to the setting of the address via online-programming. This
possibility is of importance when programming via the central unit is
not possible (e.g. Märklin* DELTA central unit).