Installation guide

DC 900-1331F 29
Chapter
1
Getting Started
This manual describes how to install the Freeway 2000/4000 hardware and configure
the boot parameters. The following is a summary of the complete installation proce-
dure:
1. Install the hardware as described in Chapter 2 of this manual.
2. Install the software onto the boot server as described in the Freeway User’s Guide.
3. Configure the Freeway system boot parameters as described in Chapter 3 of this
manual.
4. Boot the Freeway server.
5. Run the loopback test as described in the Loopback Test Procedures.
6. Customize your installation, if necessary, as described in the Freeway User’s Guide.
7. Familiarize yourself with Freeway operations as described in the Freeway User’s
Guide.