Specifications

10-2
LS 2208 Product Reference Guide
Connecting Using Undecoded Scanner Emulation
To perform Undecoded Scanner Emulation, connect the scanner to a portable data
terminal, or a controller which collects the data and interprets it for the host.
Figure 10-1. Undecoded Scanner Emulation Connection
1. Connect the Undecoded interface cable to the bottom of the scanner, as described
in Installing the Interface Cable on page 1-3.
2. Connect the other end of the interface cable to the scanner port on the portable
data terminal or controller.
3. Scan the appropriate bar codes in this chapter to configure the scanner.
WARNING
The scanner should only be connected to 5 volt decod-
ers. Connecting the scanner to a 12 volt decoder will
invalidate your warranty.
Host Port Connector
Interface cable