User`s guide

Chapter 5 - I/O Commands

PULSE MODE SELECT COMMAND (@@AP)

Applicability: M12+ Timing receivers

The M12+ Timing receiver can output either a 1PPS or 100PPS pulse train. The user selects the

pulse output signal using the Pulse Mode Select command. More information on the

characteristics of the 100PPS signal can be found on page 3.13

Default mode: 1PPS

Legacy Code Compatibility: The @@AP command structure detailed here is identical to that used

on Motorola UT+ timing receivers.

Motorola GPS Products - M12+ User's Guide Revision 6.X 09FEB05