Barcode Reader User Manual

Maintenance & Troubleshooting 7 - 5
The RFID reader does
not accept scan input.
Scanning application
is not loaded.
Verify that the unit is loaded with a scanning application. See the
System Administrator.
Unreadable bar code. Ensure the symbol is not defaced.
Distance between
exit window and bar
code is incorrect.
Ensure RFID reader is within proper scanning range.
Mobile computer is
not programmed for
the bar code.
Ensure the RFID reader is programmed to accept the type of bar
code being scanned.
Mobile computer is
not programmed to
generate a beep.
If a beep on a good decode is expected and a beep is not heard,
check that the application is set to generate a beep on good
decode.
Battery is low. If the scanner stops emitting a laser beam when the trigger is
pressed, check the battery level. When the battery is low, the
scanner shuts off before the mobile computer low battery
condition notification.
Note: If the scanner is still not reading symbols, contact the
distributor or Symbol Technologies.
Table 7-1 Troubleshooting the RFID reader (Continued)
Problem Cause Solution