Home Security System User's Manual

MICOM-2ES/2RS/2TS ALE Supplement to Owner’s Guide
• MNT
MultiNet: enable/disable the scanning of multiple ALE nets. When
enabled, this feature lets the radio communicate with stations in nets
other than the currently selected net.
• MxCH
Maximum Scan Channels: when MultiNet is enabled, the time needed
for scanning all the nets may be rather long. This parameter is used to
adapt the duration of the calling signal to the number of scanned net,
to ensure that communications are not disrupted.
You can use automatic selection, or select a specific value in the
range of 0 to 59 seconds.
• ANY
AnyCall: enable/disable the sending of AnyCalls.
• WILD
Wildcard: enable/disable the sending wildcard calls.
• AMD
Automatic Message Display: enable/disable the sending of AMD
messages.
• ILNK
Inlink: enable/disable the inlink facility, which enables notifying
other call participants when each participant disconnects from the
link. All participants must be programmed to use the same selection
(either YES or NO).
Do not enable the inlink function when communicating with a radio
that does not support the full ALE capabilities in accordance with
MIL-STD-188-141B.
• BDLK
Bidirectional link: enable/disable the automatic setting up of a link on
the best channel after a bidirectional handshake with an individual
station.
The ALE options have the following factory-default values:
• PTT Timeout
No timeout
• Alert
Yes
• External Alarm
Yes
• Auto Address
No
• Quick Call
Yes
• Minimum LQA score
0
• Accept Link Timeout
Yes
• MNT
Yes
• MxCH
Auto
• ANY
Yes
• WILD
Yes
60
_________________________________________________________________________________________________