User Manual

7
to disconnect anything. However, you may need to
connect the Network coax connector to a coax cable
that’s plugged into a nearby set-top box, router, or other
device. It’s okay to disconnect a coax cable from
something, but then you need to use the included coax
cable between the MoCA adapter’s DEVICE coax and the
device you disconnected.
2. Connect the included Ethernet cable between the MoCA
adapter’s Ethernet jack and the LAN Ethernet jack of the
device you’re connecting to the router via MoCA.
3. Plug the power cube into a live outlet, and make sure that
the On/Off button is On.
Once you have MoCA for your router and device, the Link
light should be lit for your MoCA Adapter(s). If it is lit, please
try using the device. If it’s able to access the Internet, your
device is working so you should read the next paragraph
below. If the Link light is no
t lit, check your wiring and try
power-cycling your MoCA Adapter(s). To power-cycle a
MoCA Adapter, just switch the MoCA Adapter off for a few
seconds, then switch it on. If your MoCA connection is still
NOT working, please go to the
Troubleshooting Tips section.
If your MoCA connection IS working, please read the MoCA
Security section below. Also, note that you can connect more
devices (up to 16) via MoCA back to your router. For each
device you want to connect to its own MoCA Adapter, use the
MoCA Connection for a Device diagram on page 6.