user manual

1-2 68P09308A83
DEC 2009
1 Desktop CPEi 725 User Guide
Front of the CPE
The front of the CPE unit contains LED Link/Activity indicators. The LEDs provide the
status of the unit and signal strength indicators for easy adjustment during setup.
Back of the CPE
The back of the CPE unit contains the reset switch, AC Power Connector, Ethernet
connector (RJ-45), Et he rn et LE D and ATA port (RJ-11).
Table 1-1 LED Indicator Interface
LED Status
detceted si htgnertS langiS XAMiW lluFhtgnertS langiS
when all WiMAX Signal Strength LEDs are
lit.
• All WiMAX Signal Strength LEDs are
off - very low signal detected.
• One to two WiMAX Signal Strength
LEDs are lit - low signal detected.
• Three to five WiMAX Signal Strength
LEDs are lit - high signal detected.
XAMiW eht ot ssecca gniriuqca elihWXA
MiW NAW
Network:
• All WiMAX Signal Strength LEDs vary
between ON, OFF and/or BLINKING
status.
If all five WiMAX Signal Strength LEDs are blinking, then a software up-
grade is in progress. Do NOT remove power to the CPE.
CAUTION