ET1 Enterprise Tablet Quick Start Guide

13
Connect to a WLAN Network
To set up a WLAN network:
1. Touch > Wireless & networks.
2. Slide the Wi-Fi switch to the ON position. Touch Wi-Fi. The
ET1 searches for WLANs in the area and lists them.
3. Select the desired network.
4. For open networks, the ET1 automatically connects. For
secure networks enter the required password or other
credentials then touch Connect. See the system
administrator for more information.
5. Touch .
Connect to a Mobile Data Network
To connect the ET1N2 to a mobile data network:
1. Touch > More... > Mobile networks.
2. Touch the Data enabled checkbox to turn on data connection.
A blue check appears in the checkbox.
3. Touch Data roaming checkbox to allow data communication
while roaming outside of the network. A blue check appears in
the checkbox.
4. Touch .
Battery Replacement
To replace the battery:
1. Press and hold the Power button until the menu displays.
2. Touch Battery Swap. The Scan LED lights red.
3. Wait until the Scan LED turns off.
4. Turn the ET1 over.
CAUTION Do not remove microSD card while in Battery Swap
mode.
Ensure that the Battery Swap mode procedures are
followed, otherwise the backup battery will deplete
quickly and on the ET1N2, SIM card data corruption
might occur.