ET1 Enterprise Tablet Quick Start Guide

Install the Battery

1. Remove the battery from the packaging.

2. Align the tracks on the sides of the battery with the rails of the

battery compartment.

3. Push the battery in until it snaps into place.

Charge the Battery

Before using the ET1, charge the battery using one of the

following accessories:

• Single-slot USB Docking cradle

• Four-slot Charge Only Docking cradle

• USB/Charge cable and power supply.

1. Ensure that the accessory is connected to power. See the ET1

Enterprise Tablet User Guide for more information.

2. Place the ET1 into a cradle or connect to the USB/Charge

cable.

The Battery Charge LEDs blinks yellow indicating that the

battery is charging. When the battery is fully charged

(approximately six hours) the LEDs becomes solid green.

Startup

Press the Power button to turn on the ET1. As the ET1 starts the

splash screen displays and then the Home screen appears.

Slide up to unlock the screen.

CAUTION Ensure that the correct battery is used with the ET1. On

the ET1N0 use either the 4620 mAh battery, p/n

82-149690-xx or the 5640 mAh battery, p/n

82-158261-xx. On the ET1N2 use only the 5640 mAh

battery, p/n 82-158261-xx. The battery part number is

found on the battery label.

Tracks

Rails

NOTE The battery can be charged separately using the Four-slot

Battery Charger.

NOTE For multi-user mode, refer to the ET1 Enterprise Tablet

User Guide for login procedures.