Network Router User Manual

Motorola 2247-N8 DSL Wi-Fi Gateway User Guide
Please visit www.motorola.com/us/support for FAQs and additional product documentation. 45
Q: I forgot my password, how can I access my 2247-N8?
A: Remember to use “admin” as your username. If you don't remember the password, the only way to access the 2247-N8 is to reset it following
the steps below:
Q: Can I change the wireless network (SSID) name on my 2247-N8?
A: Yes, log in to the 2247-N8 and follow the steps below to change the SSID name.
1. Refer to the diagram at right, and find the round Reset button open-
ing.
2. Carefully insert the point of a pen or an unwound paperclip into the
opening. Press and hold the recessed button:
Factory Default (“Reset”) Button

If you press the button for less than half a second, the unit will
continue to run as normal.
 If you press the button for more than 15 seconds, when you
release it, the 2247-N8 will perform a factory reset, clear all set-
tings and configurations, and reboot.
Note: To make sure the 2247-N8 Gateway returns to the factory
defaults you must hold the reset button for more than 15 seconds. When
you release it, the 2247-N8 will perform a factory reset, clear all settings
and configurations, and reboot. Keep in mind that all of your settings will
need to be reconfigured. Follow the steps in “Wireless (Wi-Fi) Network
Setup” on page 8 or “Wired (Ethernet) Network Setup” on page 13 to
reconfigure your 2247-N8.
1. Click on the Configure link located on the left side of the screen.
2. Click on the Wireless link
3. Click on the Multiple SSID link.
4. Use the Configure settings for: pull-down menu to choose the SSID that you want to rename (the default SSID is “SSID1”).
5. In the SSID Name field, enter an SSID name of up to 32 characters. Numbers, letters, and spaces are allowed.
6. Click the Apply Changes button to save the update to the 2247-N8.
You will need to reconnect all wireless devices to the network after changing the network name (SSID).