Two User Manual

PROGRAMMING
FEATURES
English
40
value. If you short press the PTT button again,
the radio will signal you the second digit value.
Figure 2: Reading Frequencies Values
Reading CTCSS/DPL Values
If you continue short pressing the PTT button
as shown in Figure 1: Entering Programming
Mode on page 37 (stage 2), the radio will move
forward to programming CTCSS/PL Codes.
When reading the values for CTCSS/PL Codes
the radio signals you the digit codes each time
you short press the PTT button.
You will have to read three digits as RDX
Series™ have up to 213 codes available (refer
to “Frequencies and Codes Charts” Section).
The following is an example of the order in
which your radio will be signaling the ‘118’
CTCSS/DPL code:
Figure 3: Example of How to Program Values
• Short press the PTT button. The radio will signal
you the first digit ‘1’.
• Short press PTT button again and the radio will
show the second digit ‘1’ and,
• Finally, short press PTT again and radio will show
the third digit ‘8’.
Mode
Idle
Programming
PTT
First
Digit
Second
Digit
PTT
Fre
q
uencies
First
Digit
CTCSS
PTT
PROGRAMMING M
PTT
Long
PTT
Long
PTT
1 2