User`s guide

10
Contents
Emulator Built-in Commands 125
To telnet to the emulation module 125
To telnet to the emulation probe 126
To use the built-in commands 127
Problems with the Target System 129
What to check first 129
To check the debug port connector signals 130
To interpret the initial prompt 132
If you see memory-related problems 136
If running from reset causes problems 137
If you see the "!ASYNC_STAT 173!" error message 137
If you see the “!ERROR 145!” error message 138
Other error messages 138
Problems with the LAN Interface (Emulation Module Only) 139
If LAN communication does not work 139
If it takes a long time to connect to the network 140
Problems with the Emulation Module 141
To run the built-in performance verification test using the logic analysis system
(Emulation Module Only) 141
To run complete performance verification tests using a telnet connection (Em-
ulation Module Only) 142
If a performance verification test fails 143
Problems with the LAN Interface (Emulation Probe Only) 144
If you cannot verify LAN communication 144
If you have LAN connection problems 145
If the "POL" LED is lit 146
If it takes a long time to connect to the network 146
Problems with the Serial Interface (Emulation Probe Only) 147
If you cannot verify RS-232 communication 147
If you have RS-232 connection problems with the MS Windows Terminal
program 148