User`s guide

18 MPC8240 and MPC8260 Emulation
Chapter 1: Overview
Emulation Probe
Minimum equipment required
The following equipment is required to use the emulation probe:
• A method for connecting the emulator to the target system. You can use an
Agilent Technologies analysis probe or you can design a debug port
connector on the target system. The target system must meet the criteria
on page 63.
• A host computer, such as a PC or workstation. You can also connect the
emulation probe to an Agilent Technologies 16600A or 16700A logic
analysis system.
• A LAN (local area network) to connect the emulation probe to the host
computer.
• A user interface on the host computer, such as a high-level source
debugger or the logic analysis system’s Emulation Control Interface.
To connect the emulation probe to a power
source
The emulation probe does not have an On/Off switch. To turn the
emulation probe on or off, plug or unplug it from the power supply.
The emulation probe is shipped from the factory with a power supply
and cord appropriate for your country. If the cord you received is not
appropriate for your electrical power outlet type, contact your Agilent
Technologies sales and service office.
WARNING:
Use only the supplied Agilent Technologies power supply and cord. Failure to
use the proper power supply could result in electric shock.
CAUTION:
Use only the supplied Agilent Technologies power supply and cord. Failure to
use the proper power supply could result in equipment damage.