User`s guide

MPC8240 and MPC8260 Emulation 21

Chapter 1: Overview

Emulation Module

This section lists equipment supplied with the emulation module and

lists the minimum equipment required to use the emulation module.

Equipment supplied

The equipment supplied with your emulation module includes:

• An Agilent Technologies 16610A emulation module. If you ordered an

emulation module as part of your Agilent Technologies 16600A or 16700A

logic analysis system, it is already installed in the frame.

• A target interface module (TIM) circuit board.

• An emulation module loopback test board (Agilent part number E3496-

66502).

• Firmware for the emulation module and/or updated software for the

Emulation Control Interface on a CD-ROM.

• A 50-pin ribbon cable for connecting the emulation module to the target

interface module or the Agilent Technologies E2480A analysis probe.

• A 16-pin ribbon cable for connecting the target interface module to the

target system.

• Torx T-8, T-10 and T-15 screwdrivers.

• This User’s Guide.