User`s guide

32 MPC8240 and MPC8260 Emulation
Chapter 2: Connecting the Emulation Probe to a LAN
To configure LAN parameters using the
built-in terminal interface
1 Set configuration switches S1 through S4 to ON, and set
the other switches as appropriate for your serial
interface.
Switch settings are printed on the bottom of the emulation
probe. If you will use a baud rate of 9600 baud, set the
switches like this:
2 Connect an ASCII terminal (or terminal emulator) to the
emulation probe’s RS-232 port with a 9-pin RS-232
cable.
Complete instructions for setting up a serial connection begin
on page 41.
3 Plug in the emulation probe’s power cord. Press the
terminal’s <RETURN> key a couple times. You should see
a prompt such as "p>", "?>", or "R>".
At this point, you are communicating with the emulation
probe’s built-in terminal interface.