User`s guide

34 MPC8240 and MPC8260 Emulation
Chapter 2: Connecting the Emulation Probe to a LAN
and connect the emulation probe to your network.
This connection can be made by using either the 10BASE-T
connector or the 10BASE2 (BNC) connector on the emulation
probe. Do not use both connectors at the same time.
7 Set the configuration switches to indicate the type of
connection that is to be made.
Switch S1 must be set to OFF, indicating that a LAN
connection is being made.
Switch S5 should be ON if you are connecting to the BNC
connector:
Switch S5 should be OFF if you are connecting to the 10BASE-
T connector:
Set all other switches to ON.
8 Connect the power cord to the emulation probe.
9 Verify your emulation probe is now active and on the
network. See “To verify LAN communications” on
page 39.
Once you have set a valid IP address, you can use the telnet
utility to connect to the emulation probe, and use the lan
command to change LAN parameters.