User`s guide

MPC8240 and MPC8260 Emulation 37
Chapter 2: Connecting the Emulation Probe to a LAN
Switch S5 should be set to OFF if you are connecting to the
BNC connector
Switch S5 should be set to ON if you are connecting to the
10BASE-T connector.
Set all other switches to ON.
5
Connect the power cord to the emulation probe.
6
Verify that the power light stays on after 10 seconds.
The IP address will be stored in EEPROM.
7
Set switch S6 back to ON.
Do this so that the emulation probe does not request its IP
address each time power is cycled. The IP address is stored in
EEPROM, so BOOTP does not need to be run again. Leaving
this switch on will result in slower performance, increased
LAN traffic, and even failure to power up (if the BOOTP server
becomes inactive).
8
Verify your emulation probe is now active and on the
network. See "To verify LAN communications" on page
39.
See Also For additional information about using bootpd, refer to the
bootpd (1M) man page.