User`s guide

MPC8240 and MPC8260 Emulation 39
Chapter 2: Connecting the Emulation Probe to a LAN
NOTE: Setting switch S8 to OFF when Link Beat integrity checking is
required by your network will cause the remote MAU to disable
communications.
To verify LAN communications
1
Verify your emulation probe is now active and on the
network by issuing a telnet to the IP address.
This connection will give you access to the emulation probe’s
built-in terminal interface.
2
To view the LAN parameters, enter the lan command at
the terminal interface prompt.
3
To exit from this telnet session, type <CTRL>D at the
prompt.
The best way to change the emulation probe’s IP address, once
it has already been set, is to telnet to the emulation probe and
use the terminal interface lan command to make the change.
Remember, after making your changes, you must cycle power
or enter a terminal interface init -p command before the
changes take effect. Doing this will break the connection and
end the telnet session.
If You Have
Problems
“If you have problems with the emulator, your first task is to
determine the source of the problem. Problems may originate
in any of the following places:” on page 120.