User`s guide

42 MPC8240 and MPC8260 Emulation
Chapter 2: Connecting the Emulation Probe to a LAN
Setting Up a Serial Connection
To set the serial configuration switches
1 Set switch S1 to ON (RS-232).
2 Set switches S2-S4 to ON.
3 Set switch S5 to ON (HW HANDSHAKE ON) if your serial
interface uses the DSR:CTS/RTS lines for flow control.
Set S5 to OFF (HW HANDSHAKE OFF) if your serial
interface uses software flow control (XON/XOFF).
If your serial interface supports hardware handshaking, you
should use it (set switch S5 to ON). Hardware handshaking
will make the serial connection much more reliable.
4 Set switches S6-S8 for the baud rate you will use. These
switch settings are listed on the bottom of the emulation
probe.
The higher baud rates may not work reliably with all hosts and
user interfaces. Make sure the baud rate you choose is
supported by your host and user interface.
Example
To use a baud rate of 9600 baud, set the switches as
follows: