User`s guide

MPC8240 and MPC8260 Emulation 43
Chapter 2: Connecting the Emulation Probe to a LAN
Setting Up a Serial Connection
To connect a serial cable
CAUTION: Use a grounded, shielded cable. If the cable is not shielded, or if the
cable is not grounded at the serial controller, the emulation probe
may be damaged by electrostatic discharge.
Connect an RS-232C modem cable from the host computer to
the emulation probe. Use a 9-pin cable with one-to-one pin
connections.
If you want to build your own RS-232 cable, follow the pinout
shown in the following figure: