User`s guide

MPC8240 and MPC8260 Emulation 45
Chapter 2: Connecting the Emulation Probe to a LAN
Setting Up a Serial Connection
To verify serial communications
1 Start a terminal emulator program on the host computer.
If you are using a PC, the Terminal application in Microsoft
Windows will work fine.
If you are using a UNIX workstation, you can use a terminal
emulator such as cu or kermit.
2 Plug the power cord into the emulation probe.
When the emulation probe powers up, it sends a message
(similar to the one that follows) to the serial port and then
displays a prompt:
Copyright (c) Agilent Technologies 1987
All Rights Reserved. Reproduction, adaptation, or translation without
prior written permission is prohibited, except as allowed under
copyright laws.
E3499B Series Emulation System
Version: A.07.56 28Sep98
Location: Generics
E3453A Motorola MPC8200 Embedded PowerPC Emulator
Version: A.01.00 18Feb99
R>
The version numbers may be different for your emulation
probe.
3 Press the Return or Enter key a few times.
You should see a prompt such as "p>", "R>", or "?>".
For information about the commands you can use, enter ? or
help at the prompt.
See Also
“If you have problems with the emulator, your first task is to
determine the source of the problem. Problems may originate
in any of the following places:” on page 120.