User`s guide

58 MPC8240 and MPC8260 Emulation
Chapter 5: Connecting and Configuring the Emulator
This chapter shows you how to connect the emulator to the target
system and how to configure the emulator and target.
Here is a summary of the steps for connecting and configuring the
emulator:
1
Make sure the target system is designed to work properly with
the emulator. (page 63)
2
Install the emulation module in your logic analysis system, if
necessary. (page 45)
3
Connect the emulator to your target system using the 16-pin
cable and the TIM or an analysis probe. (page 66)
4
Update the firmware of the emulator, if necessary. (page
107)
5
Verify communication between the emulator and the
target. (page 69)
6
Configure the emulator. (page 70)
7
Test the connection between the emulator and the target.
(page 81)
8
Connect a debugger to the emulator, if applicable. (page
83.)
See Also Chapter 6, “Using the Emulator with a Debugger,” beginning
on page 83 for information on configuration with a debugger,
and on configuring LAN port numbers.