User`s guide

MPC8240 and MPC8260 Emulation 67
Chapter 5: Connecting and Configuring the Emulator
Connecting the Emulator to the Target System
After you have connected the emulator to your target system, you may
need to update the firmware in the emulator.
See Also For information on designing a debug port on your target
board, see page 63.
For a list of the parts supplied with the emulator, see page 21.
To connect to a target system using a 16-pin
debug port
The emulator can be connected to a target system through a 16-pin
debug port (JTAG connector).
The emulator should be connected to the target system using the 16-
conductor cable assembly provided.
In order to connect the emulator to the microcontroller, a 16-pin male
2x8 header connector must be available on the target system.
1
Remove power from the target system and the emulator.
2
Plug one end of the 50-pin cable into the emulator.
3
Plug the other end of the 50-pin cable into the target interface
module.
4
Plug one end of the 16-pin cable into the target interface module.