User`s guide

MPC8240 and MPC8260 Emulation 73
Chapter 5: Connecting and Configuring the Emulator
Configuring the Emulator
To configure using a debugger
Because the Agilent Technologies emulator can be used with several
third-party debuggers, specific details for sending the configuration
commands from the debugger to the emulator cannot be given here.
However, all debuggers should provide a way of directly entering
terminal mode commands to the emulator. Ideally, you would create a
file that contains the modified configuration entries to be sent to the
emulator at the beginning of each debugger session.
See Also Information about specific debuggers in Chapter 6, “Using the
Emulator with a Debugger,” beginning on page 83.
Your debugger manual.
Example
To see a complete list of configuration items, type help cf. This
command displays:
M>help cf
cf - display or set emulation configuration
cf - display current settings for all config items
cf <item> - display current setting for specified <item>
cf <item>=<value> - set new <value> for specified <item>
cf <item> <item>=<value> <item> - set and display can be combined
help cf <item> - display long help for specified <item>
--- VALID CONFIGURATION <item> NAMES ---
proc - Set type of processor
reset - Run or stop after reset
vector - Reset vector address
rrt - Set restriction to real time runs
breakin - BNC break in control
trigout - Trigger out control
speed - Set JTAG Clock Divisor
M>