User`s guide

76 MPC8240 and MPC8260 Emulation
Chapter 5: Connecting and Configuring the Emulator
Configuring the Emulator
To configure the BNC Break In control
To configure the Trigger Out BNC (Emulation
Probe Only)
With an emulation module, this configuration item is always set to the
default setting and cannot be changed with a cf command. The
Intermodule window of the logic analysis system must be used instead.
BNC Break In control configuration
Value Emulation module configured for Built-in command
rising Causes the 'break in' input to halt the
processor on a rising edge (Default).
cf breakin=rising
falling Breaks the processor on a falling edge. cf breakin=falling
off cf breakin=off
Trigger out configuration
Value The Trigger Out BNC will Built-in command
fixhigh Always be high cf trigout=fixhigh
fixlow Always be low cf trigout=fixlow
monhigh Go high when the processor is running in
background (Default)
cf trigout=monhigh
monlow Go low when the processor is running in
background
cf trigout=monlow