Fixed-mount Imager Integration Guide

8 - 20 Symbol MS4404/MS4407 Integration Guide
Event Reporting
The host can request the decoder to provide certain information (events) relative to the decoder’s behavior. Enable
or disable the events listed in Table 8-4 and on the following pages by scanning the appropriate bar codes.
Decode Event
Parameter # F0h, 00h
When enabled, the decoder generates a message to the host whenever a bar code is successfully decoded. When
disabled, no notification is sent.
Table 8-4 Event Codes
Event Class Event Code Reported
Decode Event Non parameter decode 0x01
Boot Up Event System power-up 0x03
Parameter Event Parameter entry error
Parameter stored
Defaults set (and parameter event is enabled by default)
Number expected
0x07
0x08
0x0A
0x0F
Enable Decode Event
(01h)
*Disable Decode Event
(00h)