Fixed-mount Imager Integration Guide

11 - 34 Symbol MS4404/MS4407 Integration Guide
Code 93
Enable/Disable Code 93
Parameter # 09h
To enable or disable Code 93, capture the appropriate bar code below.
Set Lengths for Code 93
Parameter # L1 = 1Ah, L2 = 1Bh
The length of a code refers to the number of characters (i.e., human readable characters), including check digit(s)
the code contains. Set lengths for Code 93 to any length, one or two discrete lengths, or lengths within a specific
range.
• One Discrete Length - Select this option to decode only Code 93 symbols containing a selected length.
Select the length using the numeric bar codes in Appendix D, Numeric Bar Codes. For example, to decode
only Code 93 symbols with 14 characters, capture Code 93 - One Discrete Length, then capture 1 followed
by 4. To correct an error or to change the selection, capture Cancel on page D-3.
• Two Discrete Lengths - Select this option to decode only Code 93 symbols containing either of two
selected lengths. Select lengths using the numeric bar codes in Appendix D, Numeric Bar Codes. For
example, to decode only those Code 93 symbols containing either 2 or 14 characters, select Code 93 - Two
Discrete Lengths, then capture 0, 2, 1, and then 4. To correct an error or to change the selection,
capture Cancel on page D-3.
• Length Within Range - Select this option to decode a Code 93 symbol with a specific length range.
Select lengths using the numeric bar codes in Appendix D, Numeric Bar Codes. For example, to decode
Code 93 symbols containing between 4 and 12 characters, first capture Code 93 - Length Within Range.
Then capture 0, 4, 1, and 2 (single digit numbers must always be preceded by a leading zero). To correct an
error or change the selection, capture Cancel on page D-3.
• Any Length - Capture this option to decode Code 93 symbols containing any number of characters within
the imager’s capability.
Enable Code 93
(01h)
*Disable Code 93
(00h)