Fixed-mount Imager Integration Guide

12 - 4 Symbol MS4404/MS4407 Integration Guide
Prefix/Suffix Values
For SSI Hosts:
Parameter # P = 69h, S1 = 68h, S2 = 6Ah
For Non-SSI Hosts:
Key Category Parameter # P = 63h, S1 = 62h, S2 = 64h
Decimal Value Parameter # P = 69h, S1 = 68h, S2 = 6Ah
A prefix and/or one or two suffixes can be appended to decoded data for use in data editing. To set a value for a
prefix or suffix, capture a prefix or suffix bar code below, then capture a four-digit number (i.e., four bar codes from
Appendix D, Numeric Bar Codes) that corresponds to that value. See Table E-1 on page E-1 for the four-digit
codes. To correct an error or change a selection, capture Cancel on page D-3.
NOTE To use Prefix/Suffix values, first set the Scan Data Transmission Format on page 12-5.
For non-SSI hosts, when using host commands to set the prefix or suffix, set the key category parameter
to 1, then set the 3-digit decimal value. See
Table E-1 on page E-1 for the four-digit codes.
Scan Prefix
(07h)
Scan Suffix 1
(06h)
Scan Suffix 2
(08h)