Fixed-mount Imager Integration Guide

Appendix A Standard Defaults
Default Parameters
Table A-1 Standard Default Parameters Table
Parameter
Parameter
Number
Default
Page
Number
User Preferences
Set Default Parameter All Defaults 6-3
Parameter Scanning ECh Enable 6-4
Beeper Tone 91h Medium 6-4
Beeper Volume 8Ch High 6-5
Trigger Mode 8Ah Presentation 6-6
Picklist Mode F0h 92h Disabled Always 6-7
Power Mode 80h Continuous On 6-8
Time Delay to Low Power Mode 92h 1.0 Sec 6-8
Decode Session Timeout 88h 9.9 Sec 6-9
Timeout Between Decodes, Same
Symbol
89h 0.6 Sec 6-10
Beep After Good Decode 38h Enable 6-10
Presentation Mode Session Timeout F0h, 90h 2 Seconds 6-11
1
User selection is required to configure this interface and this is the most common
selection.