Fixed-mount Imager Integration Guide

User Preferences 6 - 9
Decode Session Timeout
Parameter # 88h
This parameter sets the maximum time decode processing continues during a decode attempt. It is programmable
in 0.1 second increments from 0.5 to 9.9 seconds. The default timeout is 9.9 seconds.
To set a Decode Session Timeout, capture the bar code below. Next, capture two numeric bar codes from
Appendix D, Numeric Bar Codes that correspond to the desired on time. Single digit numbers must have a leading
zero. For example, to set a Decode Session Timeout of 0.5 seconds, capture the bar code below, then capture the
0 and 5 bar codes. To correct an error or change the selection, capture Cancel on page D-3.
Time Delay to Low Power Mode (continued)
1 Minute
(21h)
5 Minutes
(25h)
15 Minutes
(2Bh)
1 Hour
(31h)
Decode Session Timeout