Fixed-mount Imager Integration Guide

Chapter 7 Imager Preferences
Overview
This chapter describes imager preference features and provides the programming bar codes for selecting these
features.
The imager ships with the settings shown in the Imager Preferences Default Table on page 7-2 (also see Appendix
A, Standard Defaults for all host device and miscellaneous defaults). If the default values suit requirements,
programming is not necessary.
There are two ways to change a parameter value:
• Capture the appropriate bar codes in this guide. These new values replace the standard default values in
memory.
• For SSI and USB SNAPI hosts, send a “parameter send” command from the host system. Hexadecimal
parameter numbers are shown in this chapter below the parameter title, and options are shown in
parenthesis beneath the accompanying bar codes. See the Simple Serial Interface (SSI) Programmer Guide
for detailed instructions for changing parameter values using this method.
Select a host type (see each host chapter for specific host information) after the power-up beep signal activates.
This is only necessary upon the first power-up when connected to a new host.
To return all features to default values, capture *Set All Defaults on page 6-3. Throughout the programming bar
code menus, default values are indicated with asterisks (
*).
NOTE Most computer monitors allow capturing the bar codes directly on the screen. When capturing from the
screen, be sure to set the document magnification to a level where the bar code can be seen clearly, and
bars and/or spaces are not merging.
Feature/Option
* Indicates Default
*Enable Decode Aiming Pattern
(02h)
Option Hex Value for
programming via SSI command