Instruction Manual

TEST SETUP & TESTING 5 - 7
System Wide Services: normal mode
18. Press “More” soft key.
TETRA Voice Service: supported
Circuit Mode Data Service: supported
(Reserved): available
SNDCP Service: available
Air Interface Encryption: not available
Advanced Link: not supported
19. Press the “Return” soft key.
20. Press the “Neighbr Cell” soft key.
21. Verify that the following NEIGHBOUR CELL INFO values are displayed:
Note: The displayed values are factory defaults and should not be changed.
NEIGHBOUR CELL BROADCAST: not REQUIRED
BROADCAST INTERVAL: 5s
NEIGHBOUR CELL CHANNEL: 3500
NEIGHBOUR CELL LOCATION AREA: 00017
NEIGHBOUR CELL IDENTIFIER: 01
SLOW RE-SELECT THRESHOLD: 10dB
PRESS “MORE” SOFT KEY
SLOW RE-SELECT HYSTERESIS: 10dB
FAST RE-SELECT THRESHOLD: 10dB
FAST RE-SELECT HYSTERESIS: 10dB
22. Press the “Return” soft key.
23. Press the “Trunk Type” soft key and the “message Trunked” soft key
(Transmission).
24. Press “More” Softkey.
Note:
The displayed values are factory defaults and should not be changed.
It is not required to configure “Call Types” “Call Arial” and “Messages”.
25. Press “More” Softkey.