User`s manual

IN-5
I
N
D
E
X
G
general description of the SCSI software
1-4
general information 1-1
glossary GL-1
H
help E-4
I
IDOV 5-12
INIT 5-12
initialization
C debug 3-8
initialization call
C firmware 3-3
initialize the NCR firmware interface
E-28
initiator GL-1
initiator mode B-3
INT 5-12
INTATR (command control bit 31) B-3
interface
assembler 3-2
C call 3-1
debug logging 5-1
firmware 2-2, 3-1
interrupt handler
C SIOP firmware 3-7
interrupt mechanism 2-8
interrupt mode 2-6
introduction 1-1, 2-1, 3-1, 4-1, 5-1, A-1,
B-1, C-1, E-1
issue a format command E-23
issue a read command to the device E-34
issue an INQIRY command E-22
issue reads and writes to a disk device
E-24
issue sdl_cntrl command E-9
issue sdl_init command E-8
issue sdl_read command E-8
issue sdl_write command E-9
issue siop_cmd command E-14
issue siop_init command E-14
K
KICK 5-12
L
LCMP 5-13
LINK (command control bit 6) B-8
link pointer B-14
local bus usage by the NCR 53C710 5-16
logical end B-17
logical unit GL-1
LUN B-10, GL-1
M
main menu E-3
makefile 4-2
manual
organization 1-1
map
firmware debug log 5-9
firmware display frame 5-10
memory structure
debug trace 5-2, 5-3
menu expansion E-16
menu item descriptions E-3
message handling 2-10
message-in buffer pointer B-12
message-in bytes (0-B) B-12
message-in length B-11
message-out buffer pointer B-13
message-out bytes (0-B) B-13
message-out length B-12
MIBUF (command control bit 15) B-6
MOBUF (command control bit 14) B-6
mode
interrupt 2-6
polled 2-7
mode bits B-3
mode sense parameters E-32
MPU GL-1